Analysis of stability of silica nano-particle-laden microbubble dispersion

Microbubbles are small gas-filled bubbles which have wide application in various industries. The stability of microbubble is of primary concern for the application of microbubble. In this research, the stability of microbubble dispersion generated using CTAB surfactant is analyzed by drainage mechanism. The stability of microbubble dispersion is studied on the basis of the half-life of microbubble dispersion. Microbubble dispersion gas fraction and apparent rise velocity of interface of microbubble dispersion are also calculated. The size of microbubble is estimated from the apparent rise velocity of interface of microbubble dispersion. Further, silica nano-particles are added to the surfactants to study their effect on the stability of microbubble dispersion. The observed results clearly indicate that the stability of microbubble dispersion is significantly affected by the surfactant concentration and the weight of silica nano-particle in the liquid. Similar results were observed for the apparent rise velocity of interface and bubble size of dispersion. The present work may be beneficial for the application of microbubble in various chemical and biochemical industries and scientific community.

     

Photosynthetic production and its regulating factors in the Baltic Sea

Measurements of primary production in the Baltic Sea over a period of 2 years (1969/1971) by the ¹⁴C method are reported. The rate of total annual production for the Baltic Sea proper and the Gulf of Finland including coastal areas appears to lie between 35 and 40 gC·m², a rate which can be assumed as characteristic for oligotrophic waters with a low production rate. An apparent increase in productivity between the 2 years could be noted. Calculations for the water mass below the halocline show that between 0.7 and 0.8 ml/l oxygen is used up during a period of 3 months required for the development of anoxic conditions. The major portion of the organic matter in the Baltic Sea undergoes decomposition in the sub-photic zone above the halocline. The ratio of organic material in deep water to the total available oxidizable matter appears to remain constant with time; therefore, the apparent increase in productivity in the photic layer does not affect apprecibly the development of anoxic conditions in deep water. Of the different areas investigated, the Gulf of Finland seems to be the most productive. In the southern Baltic Sea, the rate of production over 5 years between 1966 and 1971 has not changed appreciably. In fact, it shows a trend toward a slight decrease, whereas, in other areas of the Baltic Sea, the rate of production indicates an apparent increase. Comparison with oceanic coastal areas of the west coast of Sweden shows that the rate of production there is higher than in the Baltic Sea. Of the micronutrients controlling productivity in the photic layer of the Baltic Sea, nitrate has a stronger limiting effect on plant growth than phosphate, a fact which is in agreement with existing conceptions on the subject. Dissolved iron does not seem to exert any appreciable influence on the productivity.     

Biofilm mediated degradation of commercially available LDPE films by bacterial strains isolated from partially degraded plastic

Biodegradation is an attractive approach for the elimination of synthetic polymers, pervasively accumulated in natural environments and generating ecological problems. The present work investigated the degradation of low‐density polyethylene (PE) by three Bacillus sp., that is, ISJ36, ISJ38, and ISJ40. The degree of biodegradation was assessed by measuring hydrophobicity, viability, and total protein content of bacterial biofilm attached to the PE surface. Although all three bacterial strains were able to establish an active biofilm community on the PE surface, ISJ40 showed better affinity toward PE degradation than the other two. Bacterial colonization and physical changes on the PE surface were visualized by scanning electron microscopy. Fourier transform infrared spectroscopy analysis revealed alteration in the intensities of functional groups along with an increase in the carbonyl bond indexes. The study results suggest that the Bacillus strain ISJ40 can be used as a potential degrader for the eco‐friendly treatment of PE waste.     

Synergistic Effect of Oil Palm Based Pozzolanic Materials/Oil Palm Waste on Polyester Hybrid Composite

This research work aims to investigate the synergistic effect of pozzolanic materials such as oil palm ash (OPA) and oil palm empty fruit bunch (OPEFB) on the developed hybrid polymer composites. The OPEFB and OPA fillers of different particle sizes (250, 150, and 75 µm) were mixed at OPEFB:OPA ratios of (0:100; 20:80; 40:60; 60:40; 80:20 and 100:0) and incorporated into an unsaturated polyester resin. Furthermore, both mechanical and morphological properties of the composites were analyzed and it was found that tensile, flexural, and impact properties were significantly improved at OPEFB:OPA of 75 µm particle size hybridization of the polymer. The increase of OPEFB to OPA filler ratio up to 80:20 significantly improved the tensile properties of the composites while 40:60 ratio of 75 µm gave the optimum filler ratio to obtain the highest flexural and impact properties of the composites among all studied samples. Scanning electron micrograph images showed strong particle dispersion of the embedded fillers with resin which explained the excellent mechanical strength enhancement of the composite.     

Removal and recovery of toxic nanosized Cerium Oxide using eco-friendly Iron Oxide Nanoparticles

• Eco-friendly IONPs were synthesized through solvothermal method. • IONPs show very high removal efficiency for CeO₂ NPs i.e. 688 mg/g. • Removal was >90% in all synthetic and real water samples. • >80% recovery of CeO₂ NPs through sonication confirms reusability of IONPs. Increasing applications of metal oxide nanoparticles and their release in the natural environment is a serious concern due to their toxic nature. Therefore, it is essential to have eco-friendly solutions for the remediation of toxic metal oxides in an aqueous environment. In the present study, eco-friendly Iron Oxide Nanoparticles (IONPs) are synthesized using solvothermal technique and successfully characterized using scanning and transmission electron microscopy (SEM and TEM respectively) and powder X-Ray diffraction (PXRD). These IONPs were further utilized for the remediation of toxic metal oxide nanoparticle, i.e., CeO₂. Sorption experiments were also performed in complex aqueous solutions and real water samples to check its applicability in the natural environment. Reusability study was performed to show cost-effectiveness. Results show that these 200 nm-sized spherical IONPs, as revealed by SEM and TEM analysis, were magnetite (Fe₃O₄) and contained short-range crystallinity as confirmed from XRD spectra. Sorption experiments show that the composite follows the pseudo-second-order kinetic model. Further R²>0.99 for Langmuir sorption isotherm suggests chemisorption as probable removal mechanism with monolayer sorption of CeO₂ NPs on IONP. More than 80% recovery of adsorbed CeO₂ NPs through ultrasonication and magnetic separation of reaction precipitate confirms reusability of IONPs. Obtained removal % of CeO₂ in various synthetic and real water samples was>90% signifying that IONPs are candidate adsorbent for the removal and recovery of toxic metal oxide nanoparticles from contaminated environmental water samples.     

Clinical effects and cholinesterase activity changes in workers exposed to Phorate (Thimet)

Phorate (Thimet), an aliphatic derivative of phosphorus is a highly toxic insecticide. In order to implement the safety measures, the clinical manifestations and cholinesterase (ChE) activity were evaluated before and after 2 weeks of exposure to this insecticide in 40 male formulators. The 2 week's exposure reveal signs and symptoms of toxicity in 60% of the formulators. Gastrointestinal symptoms and lowering of heart rate (bradycardia) were more prominent as compared to the neurological symptoms. A significant depression in plasma ChE activity was observed at the end of 1st week (55%) and 2nd week (71%) as compared to the respective pre-exposure values. A recovery up to 79% of the pre-exposure activity of this enzyme was noticed 10 days after cessation of the above exposure.     

Fate and bioavailability of arsenic in organo-arsenical pesticide-applied soils. Part-I: incubation study

A laboratory incubation study was conducted to estimate geochemical speciation and in vitro bioavailability of arsenic as a function of soil properties. Two chemically-variant soil types were chosen, based on their potential differences with respect to arsenic reactivity: an acid sand with minimal arsenic retention capacity and a sandy loam with relatively high concentration of amorphous Fe/Al-oxides, considered a sink for arsenic. The soils were amended with dimethylarsenic acid (DMA) at three rates: 45, 225, and 450 mg/kg. A sequential extraction scheme was employed to identify the geochemical forms of arsenic in soils, which were correlated with the "in vitro" bioavailable fractions of arsenic to identify the most bioavailable species. Arsenic bioavailability and speciation studies were done at 0 time (immediately after spiking the soils with pesticide) and after four-months incubation. Results show that soil properties greatly impact geochemical speciation and bioavailability of DMA; soils with high concentrations of amorphous Fe/Al oxides retain more arsenic, thereby rendering them less bioavailable. Results also indicate that the use of organic arsenicals as pesticides in mineral soils may not be a safe practice from the viewpoint of human health risk.     

Evaluation and standardisation of a simple HG-AAS method for rapid speciation of As(III) and As(V) in some contaminated groundwater samples of West Bengal, India

A simple HG-AAS technique has been evaluated and standardised for rapid speciation of As(III) and As(V) in a number of contaminated groundwater samples of West Bengal, India. Citric acid has been used for selective hydride formation of As(III). The sensitivity of the evaluated HG-AAS method is 7.91 mg(-1)l, standard deviation, 0.001 and detection limit, 0.4 microg l(-1). As(III) sensitivity remains constant in the sample pH range of 2.3-10.6. Concomitant mineral matrix of the water samples did not interfere with arsenic determination. Eight out of ten groundwater samples analysed for As(IlI)and As(V) contain more As(III), which lies in the range of 54-350 ppb. As(III) estimation in drinking water along with total arsenic should be invoked as a policy for a realistic risk assessment of the contaminated water.     

Effect of concentration,moisture and soil type on the dissipation of flufenacet from soil

Effect of concentration, moisture and soil type on dissipation of flufenacet from soil has been studied under laboratory condition. The treated soil samples (1 and 10 microg/g levels) were incubated at 25+/-1 degrees C. The effect of moisture was studied by maintaining the treated soil samples (10 microg/g level) at field capacity and submerged condition. In general, flufenacet persisted for 60-90 days at lower and beyond 90 days at high rate. The dissipation of flufenacet from soil followed first order kinetics with half-life (DT50) values ranging from 10 to 31 days. The dissipation of flufenacet was faster at low rate than high rate of application. The slow dissipation at high rate could be attributed to inhibition of microbial activity at high rate. There was little overall difference in rate of dissipation in Ranchi and Nagpur soil maintained at field capacity and submerged condition moisture regimes. In Delhi soil net dissipation was faster under field capacity moisture than submerged condition. Soil types greatly influenced the dissipation of flufenacet. Dissipation was fastest in Delhi soil (DT50 10.1-22.3 days) followed by Ranchi soil (DT50 10.5-24.1 days) and least in Nagpur soil (DT50 29.2-31.0 days). The difference in dissipation could be attributed to the magnitude of adsorption and desorption of flufenacet in these soils.